-
Notifications
You must be signed in to change notification settings - Fork 428
M100 N1 Video Encoder board
Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics
The Air Side Video Encoder board does real-time digital video stream compression for radio transfer. That stream can then be decoded and viewed on Ground Side.
Known versions of the board are listed below. Additionally, the board is very similar to IG800 Video Encoder board.
Marking | Overview |
---|---|
P00303.02 |
Marking | Amt. | Pkg. | Function | Specification |
---|---|---|---|---|
ADV7650 66C2-P #5116 | 1 | Analog Devices HDMI decoder chip | ||
TI DM368ZCED ? 570 | 1 | Media Processor | ||
ISSI 1519 IS43DR160408 ??SDRLI K003 | RAM | |||
Micron ???? NW3?? | NAND; barely readable, NW362 or NW351 | |||
C ?? ?? | 1 | Atmel AT88/ATSHA204 | ||
5151? TI ????? | 1 | QFN-8888 | Texas Instruments TVP5151 Ultralow-Power NTSC/PAL/SECAM Video Decoder; 9-Bit Analog-to-Digital Converter | description |
PA 6LB/67A | 1 | 3x3 UDFN/WSON | Mini Linear Regultor; part used is DI AP7361ADJ, but it could also be TI TPS7A16 | DI datasheet TI description |
Chips | Firmware | Description |
---|---|---|
DM368, IS43DR?, MX30LF1G/MT29F1G? | m0800 | Live feed video encoding. |
Marking | Overview |
---|---|
TODO |
The following service pads exist on this board:
Marking | Overview |
---|---|
TODO |
Top of a P00303.02 board:
Bottom of the P00303.02 board:
No schematics available.
This page is created by drone enthusiasts for drone enthusiasts.
If you see a mistake, or you know more about specific subject, or you see an area for improvement for the wiki - create an issue in this project and attach your patch (or describe the change you propose).